Display with Button for Jack JK-9100BS/JK-9100BP Machine

Display with button for Jack JK-9100BS and JK-9100BP single needle direct-drive lockstitch machines. This front panel shows machine settings and function status, so replace it when the screen is cracked, blank or the button no longer responds.

Fits

• Jack JK-9100BS
• Jack JK-9100BP

When to Replace It

• The screen is cracked, dim or completely blank.
• Characters look garbled or segments are missing.
• The button does not respond when pressed.

How to Replace the Display

1. First, switch the machine off and unplug it.
2. Next, open the panel cover and note how the display cable is connected, so the new one goes back the same way.
3. Then disconnect the old display and fit the new one with its button in the same position.
4. Finally, close the cover, power on and check that the settings show clearly.

अक्सर पूछे जाने वाले प्रश्न

How do I confirm this display fits my machine?

Check the model plate on the machine arm: it should read JK-9100BS or JK-9100BP. If your machine shows a different model, message us before ordering so we can match the right panel.

My screen is blank. Is the display always the problem?

Not always. A loose display cable can look the same as a failed panel. With the power off, reseat the cable first; if the screen stays blank or garbled after that, the display itself is the likely fault.

More parts for this model: Jack 9100 / 9100BP / 9100BS spare parts.