4L Gravity Feed Steam Iron with Water Tank

This 4L industrial steam iron uses a gravity-feed water tank — a tank mounted above the iron that feeds water down into the iron’s own heating element to generate steam. It’s the simpler of our two industrial steam iron setups, suited to tailoring shops and boutiques that need steady steam output without running a separate boiler unit.

Gravity-Feed vs Boiler: Why It Matters

Industrial steam irons come in two main types. A gravity-feed iron like this one has a water tank sitting above the iron; gravity pushes water down into the iron’s heating chamber, where it turns to steam on demand. A boiler-based iron instead uses a separate pressurized boiler unit that generates steam continuously and feeds it to the iron through a hose — better suited to high-volume, all-day pressing. This 4L water tank model is the gravity-feed type: simpler to set up, no separate boiler to maintain, and a good fit for shops that press steadily through the day rather than running continuous high-pressure steam.

Key Details

• 4L gravity-feed water tank mounted above the iron
• No separate boiler unit — steam is generated in the iron itself
• Suited to tailoring shops, boutiques, and moderate daily pressing volumes
• Simpler setup and maintenance than a boiler-based system

Who It’s Built For

Tailoring shops and boutiques doing regular garment pressing who want reliable steam output without the extra setup and upkeep of a separate boiler unit. If you’re pressing heavy fabric continuously all day at high volume, our 2000W Boiler Steam Iron is built for that heavier-duty use instead.

का उपयोग कैसे करें

First, fill the 4L tank with clean water and mount it in its bracket above the iron. Next, switch on and allow the iron to heat before pressing. Then, press fabric with steady, even strokes, refilling the tank when it runs low. Finally, switch off and let the iron cool fully before storing.

अक्सर पूछे जाने वाले प्रश्नों

What’s the difference between this and your boiler steam iron?

This model uses a gravity-feed water tank — water flows down into the iron by gravity and turns to steam there. Our 2000W Boiler Steam Iron uses a separate pressurized boiler that generates steam continuously, better suited to high-volume, all-day pressing.

Is a gravity-feed iron good enough for daily tailoring use?

Yes, for regular tailoring and boutique pressing volumes. It’s a simpler system than a boiler-based setup, with less to maintain, and suits steady daily use well.

Do I need to refill the tank often?

That depends on how much pressing you’re doing — steady daily use will need periodic refills through the day, same as any gravity-feed steam iron.

Does it need a separate boiler unit?

No — that’s the main advantage of this model. Steam is generated inside the iron itself, so there’s no separate boiler to plumb in or maintain.