E809 Needle Plate for Siruba 747 4-Thread Overlock

The E809 Needle Plate is a genuine throat/needle plate for the Siruba 747 (700F) 4-thread overlock machine, also used on select Juki 3314 setups. It sits beneath the presser foot and guides the fabric past the feed dog and needles, with a stitch-width gauge built into the plate design. Best for garment factories and tailoring units where the plate has worn, chipped or needs replacing for a specific fabric type.

• Genuine part number E809, matched to the Siruba 747/700F 4-thread platform
• Precision stitch-width gauge for consistent overlock seam width
• Smooth-finished needle and looper openings reduce thread snagging
• Direct OEM fit onto the existing bed mounting
• An E809X variant exists specifically for thin, delicate fabrics

उपयोग के मामले

• Replacing a worn or chipped plate causing snagged thread or uneven feed
• Standard overlock production on medium-weight woven and knit fabrics
• Routine overhaul of a heavily used Siruba 747 line

फ़ायदे

• Maintains accurate, consistent stitch width across the seam
• Smooth openings reduce the thread snagging that causes skipped stitches
• A moderate-cost part that restores feed and stitch consistency without a bed overhaul

मशीन अनुकूलता

विशेष विवरण

How To Replace This Needle Plate

1. First, switch off the machine and remove the presser foot and needles.
2. Next, remove the mounting screws holding the old plate to the bed.
3. Then, lift away the worn E809 plate and clean any lint from the feed dog area.
4. After that, fit the replacement plate, aligning the needle and looper openings correctly.
5. Following this, refit the needles and presser foot, checking clearance around the openings.
6. Finally, run a test seam to confirm consistent stitch width before full production.

अक्सर पूछे जाने वाले सवाल

How do I know the needle plate needs replacing?

Thread snagging around the needle or looper openings, inconsistent stitch width, or visible chips and burrs on the plate surface are the usual signs. A worn plate often shows up first as intermittent skipped stitches rather than a total failure.

What’s the difference between E809 and E809X?

Both fit the same Siruba 747/700F platform, but E809X is cut specifically for thin, delicate fabrics where the standard E809 opening can be too wide and let lightweight material shift or pucker.

Does this fit my Juki machine too?

Some Juki 3314 setups use a compatible E809 plate, but bed dimensions can vary by configuration. Confirm your exact model and compare plate dimensions before ordering if you’re not on the Siruba 747/700F specifically.

Can a chipped plate be filed smooth instead of replaced?

Light filing can temporarily reduce snagging, but it changes the opening’s original tolerance, which affects stitch consistency going forward. For reliable results, replacing the plate is the more dependable fix.

Does this ship with COD and pan-India delivery?

Yes, this plate ships pan-India with cash-on-delivery available on eligible orders, along with GST billing for business buyers.

You May Also Need

• Sewing machine needle plates
• KC24 Front Cover Hinge for Siruba 747
• Siruba LP21 Looper (747 Series)
• 1.5 Red Screwdriver for Overlock Sewing Machine