Jack 10122114 Face Plate Gasket

The Jack 10122114 Face Plate Gasket is a genuine OEM sealing gasket that fits between the face plate cover and the machine head on Jack direct-drive lockstitch machines. It shares the same 10122-series part numbering as the Jack F4’s side plate gasket, so it’s commonly used on F4 and related direct-drive heads. Best for garment factories and technicians resealing a face plate that’s weeping oil or being opened for any other repair.

• Genuine Jack part number 10122114
• Cut to the exact profile of the face plate opening
• Oil-resistant material holds its seal under continuous running
• Thin, flexible construction seats flush without warping the cover
• Supplied as genuine OEM stock, not a hand-cut generic sheet

उपयोग के मामले

• Resealing the face plate during an oil leak repair
• Fitting a fresh gasket any time the face plate is opened for needle bar or hook work
• Rebuilding a used or reconditioned Jack lockstitch head before resale

फ़ायदे

• Stops oil seepage around the face plate that stains fabric during high-speed stitching
• Exact-cut fit avoids the uneven seal a hand-cut generic gasket often leaves at the corners
• Cheap, quick fix that heads off a bigger oil-related repair later

मशीन अनुकूलता

विशेष विवरण

How To Replace This Gasket

1. First, switch off the machine and remove the face plate screws.
2. Next, lift the face plate away and peel off the old, hardened gasket.
3. Then, wipe the mating surface clean of old gasket residue and oil film.
4. After that, position the new 10122114 gasket so every screw hole lines up cleanly.
5. Following this, refit the face plate and tighten the screws evenly in sequence.
6. Finally, run the machine briefly and check the seam for fresh seepage before returning it to full production.

अक्सर पूछे जाने वाले सवाल

How is this different from the 10122113 side plate gasket?

Both seal the same oil-lubricated head assembly but at different covers — 10122113 seals the side plate while 10122114 seals the face plate. They’re not interchangeable since the cut profiles differ, even though both belong to the same Jack 10122-series numbering.

How do I know it’s time to replace this gasket?

Oil residue building up around the face plate seam, a hardened or cracked-looking gasket when the cover is opened, or the sump losing oil faster than usual are the usual signs technicians look for.

Can I reuse the old gasket if it still looks intact?

A gasket that’s been compressed once rarely reseals as well a second time, since the material loses its ability to spring back into small surface irregularities. For a lasting seal, fit a fresh gasket whenever the face plate comes off.

Does this fit every Jack direct-drive machine?

It’s confirmed for the F4 and closely related direct-drive heads that share the 10122-series parts. For a different Jack model, compare your existing gasket’s outline against 10122114 before ordering rather than assuming a direct swap.

Does this ship with COD and pan-India delivery?

Yes, this gasket ships pan-India with cash-on-delivery available on eligible orders, along with GST billing for business buyers.

You May Also Need

• Jack F4 / F5 / F6 spare parts
• Jack 10122113 Side Plate Gasket for F4
• Genuine Jack F4 F5 Servo Motor Set with Control Box
• Jack A2C A2-CZ PCB Control Board 9950014900