1/4 937 Needle Clamp for Feed-Off-the-Arm Machine

The 1/4 937 Needle Clamp holds the needles in position at the 1/4-inch gauge on feed-off-the-arm machines such as the Brother DA-9270 / DA-9280 and Jack JK-9270D-13. Best for garment factories and tailors running 3-needle lap-seam work whose old clamp no longer grips the needles square.

Part Details

When to Replace It

• Needles slip or sit crooked after tightening.
• Stitch lines drift or needles strike the needle plate.
• You are fitting a fresh 937 gauge set and want the clamp to match.

How to Fit It

1. First, switch off the machine and unplug it.
2. Next, remove the needles and unscrew the old clamp from the needle bar.
3. Then fit the new clamp and insert the needles fully before tightening.
4. Finally, turn the hand wheel slowly to check the needles clear the needle plate.

पूछे जाने वाले प्रश्न

Which machines does this needle clamp fit?

It fits the Brother DA-9270 and DA-9280 and the Jack JK-9270D-13 feed-off-the-arm machines, built for the 1/4-inch 937 gauge. Compare your old clamp with the gauge before ordering.

How do I know the needle clamp is worn?

If needles loosen between shifts or cannot be set square even with a new needle, the clamp seat is usually worn. Replacing it is cheaper than repeated needle breakage.

Can I order with cash on delivery?

Yes. StitchPartner delivers pan-India with COD available. Quote the part name when ordering so the correct gauge is dispatched.