Pegasus 277323/277325 Feed Dog Set for EX3216 5-Thread Overlock

The Pegasus 277323 / 277325 Feed Dog Set is a genuine part for Pegasus 5-thread (EX3216) overlock sewing machines, moving fabric forward under the presser foot in sync with the needle stroke to form a consistent stitch length. Best for garment factories and tailoring units where worn feed dog teeth are causing fabric slip, uneven stitch length, or skipped feed on heavier fabric.

• Genuine Pegasus part numbers 277323 and 277325 (matched set)
• Precision-cut teeth for consistent fabric grip
• Hardened surface resists the wear that comes from continuous high-speed feeding
• Matched pair keeps front and rear feed sections working in sync
• Direct OEM fit onto the existing feed dog mounting

Use Cases

• Replacing worn or rounded-off feed dog teeth causing fabric slip
• Fixing inconsistent stitch length on heavier or slippery fabrics
• Routine overhaul of a high-volume Pegasus overlock line

Benefits

• Restores positive fabric grip, reducing puckering and inconsistent stitch length
• Matched front/rear set keeps feed timing consistent across the plate
• A moderate-cost fix that avoids the bigger repair of a worn feed mechanism

Machine Compatibility

Specifications

How To Replace This Feed Dog Set

1. First, switch off the machine and remove the needle plate for access.
2. Next, remove the mounting screws holding the old feed dog set in place.
3. Then, lift out the worn feed dogs and clean any lint or debris from the mounting area.
4. After that, fit the new 277323/277325 set, making sure both pieces align flush with the needle plate.
5. Following this, refit the needle plate and check the feed dog teeth sit just below the plate surface.
6. Finally, run a test seam on your usual fabric to confirm even feed before full production.

Frequently Asked Questions

How do I know the feed dog teeth are worn?

Fabric slipping under the presser foot, stitch length becoming inconsistent, or visibly rounded-off teeth when you inspect the plate are the usual signs. Heavier or slippery synthetic fabrics show this wear faster than light cottons.

Do I need to replace both pieces even if only one looks worn?

Yes — the set is matched so front and rear sections feed in sync. Replacing only one piece can leave a height or timing mismatch between old and new teeth, which shows up as uneven stitching.

Will this fit my exact Pegasus overlock model?

Pegasus uses several feed dog part numbers across its 5-thread (EX3216) range depending on the exact model and needle gauge. Compare your existing feed dog’s dimensions and part markings against 277323/277325 before ordering.

Can worn feed dogs damage the fabric itself?

Rounded or chipped teeth can snag delicate fabrics or leave visible feed marks on fine materials, in addition to causing the stitch-length inconsistency most operators notice first.

Does this ship with COD and GST billing?

Yes, this set ships pan-India with cash-on-delivery available on eligible orders, along with GST billing for factory buyers.

You May Also Need

• Pegasus sewing machine spare parts
• Pegasus 270043 270044 Side Cover Lever Set
• Pegasus EX3200 Needle Plate 277517R40