Q5 Adjustable Edge Guide Roller Hemming Presser Foot

The Q5 Adjustable Edge Guide Roller Hemming Presser Foot rolls and folds the raw edge of light fabric inward as you stitch, finishing a narrow rolled hem in one pass instead of folding and pressing first. Best for tailors and boutiques hemming scarves, dupattas, voile kurtis and napkin edges on a standard industrial lockstitch machine.

Key Features

• Roller-and-scroll design curls the raw edge inward and folds it again in one stitching pass, so the rolled hem forms without a separate folding step
• Adjustable edge guide screw lets you set and lock the hem width before a production run
• Sized for a narrower rolled hem, the usual target width for light fabrics such as chiffon, voile, cotton lawn and scarves
• Fits a standard industrial single-needle lockstitch machine with a low-shank presser bar
• Metal body built for continuous factory use

Use Cases

• Rolling and hemming scarf and dupatta edges
• Finishing napkin, handkerchief and light-garment hems in one pass
• Boutique and tailor production runs that need a consistent narrow hem across many pieces

Benefits

• Skips the separate fold-and-press step before stitching
• Keeps hem width consistent across a long run once the guide is locked
• Feeds slippery, light fabric more evenly than a standard foot alone

How the Q5 Compares

Specs

How to Fit and Use It

First, loosen the guide screw and set the roller against the fabric edge at the hem width you want. Next, fold the fabric edge over the roller by hand for the first stitch or two to start the roll. Then, feed the fabric evenly and let the roller curl and fold the edge as you stitch. Finally, lock the guide screw once you’re happy with the width so it stays consistent for the rest of the run.

Frequently Asked Questions

What is the Q5 roller hemming foot used for?

It rolls and folds the raw edge of light fabric inward as you stitch, giving a narrow finished hem in one pass — commonly used for scarf, dupatta, napkin and light-garment edges that would otherwise need a separate fold-and-press step.

Will this fit my industrial sewing machine?

It fits a standard industrial single-needle lockstitch machine with a low-shank presser bar, the most common setup on Jack, Juki, Brother and similar machines. Check your machine’s shank type before ordering if you’re not sure.

What’s the difference between the Q5 and Q7 roller hemming foot?

The Q5 gives a narrower rolled hem suited to light fabrics like chiffon and voile; the Q7 gives a slightly wider roll suited to light-to-medium fabrics like cotton and linen. Pick based on the fabric weight and hem width you need.

Does it work on slippery fabrics like chiffon or satin?

Yes — the roller is specifically there to feed slippery, light fabric evenly under the needle, which a flat standard foot struggles with on its own.

How do I keep the hem width consistent across a production run?

Set the width on a test piece first, then lock the adjustable guide screw — once locked, it holds that same width through the rest of the run without needing to re-check each piece.